Specifications

12 Chapter 2 - Controller Jumper Settings
E271-2210 SERIAL CONTROLLER
The following figure shows the mounting dimensions, jumper locations,
connections, and pinouts for the E271-2210 controller. Mounting holes marked
with an 'X' are non-plated through-holes (NPTH).
Figure 2-3. E271-2210 Serial Controller
The following table lists the jumper settings for the E271-2210 controller. These
settings are identical in function to those of the E271-2200 controller.
Baud Rate (From Left)
9600 J0-N
J1-N
2400 J0-Y
J1-N
1200 J0-N
J1-Y
300 J0-Y
J1-Y
19200 Cross connect (connect jumper
horizontally so the top pins of J0 and J1
are jumpered)
Output Format
Binary J2-N
ASCII J2-Y
Hardware Handshaking
Enabled J3-N
Disabled J3-Y