Specifications

32 Chapter 3 - Installation and Connections
E271-2202 MICRO CHANNEL CONTROLLER
E271-2202 Installation
1. Copy the file @6253.ADF from the ELODEV User's Disk, the MonitorMouse
for OS/2 (version 2.0 or later) distribution disk, or the SmartSet Companion
Disk to your Backup Copy of your "IBM PS/2 Reference Disk". If you do not
have a backup of your Reference Disk, boot with the Reference Disk in drive
A and follow the on screen instructions to create one.
2. Follow the "Installing an Adapter" instructions in your IBM Personal System/2
Quick Reference. The controller (adapter) may be installed in any available
slot.
3. If you have a TouchMonitor, plug the DB9 female end of the supplied
touchscreen cable into the DB9 male connector labeled "Touchscreen
Interface" on the back of the TouchMonitor case. Attach the opposite end of
the cable, DB9 male, to the DB9 female connector on the controller. Do not
confuse the touchscreen and video connections.
If you do not have a TouchMonitor, see E271-2201 Connections, page 31, for
the E271-2202 touchscreen connector pinouts. (The E271-2202 uses the same
connections as the E271-2201.)
4. Power on with your backup copy of the Reference Disk in drive A. Error 165
-- Adapter Configuration Error -- will appear because you just installed a new
adapter. Press [Enter] on the logo screen, then follow the on screen
instructions to "Automatically configure the system."
5. Next, follow the on screen instructions to "View Configuration" and verify that
the E271-2202 controller was detected. You should see installed in a slot the
"Elo TouchSystems E271-2202 Touchscreen Controller". The Base I/O Port
and selected Interrupt (IRQ) will also be shown. Later, if you have problems or
require a different setup, you can "Change Configuration" of the controller's
Base I/O Port and Interrupt.
6. Quit the program, remove the Reference Disk, and restart the computer. The
system should now boot without any error messages.
E271-2202 Connections
See E271-2201 Connections, page 31.