Specifications

Command Descriptions 75
Report ('B','b')
Function: Controls the timing characteristics of touch packet reporting.
0 1 2 3 4 5 6 7
Query: 'b'
Set: This command cannot be set.
Set or 0 1 2 3 4 5 6 7
Response: 'B' Untouch RepDelay
The Untouch byte specifies the number (0 15) of 10ms time increments to delay
before reporting an untouch condition. Increasing this value allows the controller
to filter out accidental untouches due to skips while sliding the finger. The factory
default value is 0.
The RepDelay byte specifies a delay (0-255) in 10ms time increments between the
transmission of touch packets. This is used to slow the output rate of the controller
without changing other filtering or interface characteristics such as the baud rate.
The factory default value is 2.