User`s guide

CARROLL TOUCH Appendix A - Error Messages
Touch System Diagnostics (CTDIAG) User’s Guide A-3
Message: Autodetection failed. No Touch System
listed in CTDIAG.CFG was found.
Check the CTDIAG.CFG file to insure
your touch system is specified in an
entry.
Check to insure that the touch system
is installed properly.
Press ‘ENTER’ to proceed to the con-
figuration menu or press ‘ESC’ to
exit.
Meaning: Autodetection has examined all entries in the .CFG file
and has not detected any of the configurations.
Action: Take the corrective action specified and either proceed to
the Test Configuration Menu or exit.
Message: CMDERR Indicated in Report Packet -
Report Type
Meaning: A report indicates an error occurred. This indication
appears as a non-zero in the third byte of the report. The
report type is the value contained in the fourth byte of
the report and appears in the error message as follows:
ProtocolVersion Report, SwitchToClassicSfp Report,
TouchState Report, TouchMode Report,
CoordinateRanges Report, Waveform Report
Action: Select Debug from the Test Menu and examine the
Trace history to determine more about the condition.
Message: COM x does not exist
Meaning: The selected comm port cannot be detected.
Action: Type a command line with the proper serial port
identified by the C switch.
Message: Controller initialized ok but frame
not found
Meaning: The controller is an HBC and no frame is detected.
Action: Autodetection proceeds to the next .CFG file
configuration. If the desired configuration is the HBC
configuration, terminate and ensure the frame is
properly attached to the HBC.
Table A-1. Error Messages (Continued)