User`s guide

CARROLL TOUCH Appendix A - Error Messages
Touch System Diagnostics (CTDIAG) User’s Guide A-9
Message: The SBC controller type cannot be used
with the Direct interface method
Meaning: A test is attempted with the SBC and the direct interface
method selected.
Action: If the SBC controller is selected, the TAPI interface
method must be selected.
Message: Touch did not de-activate. Touch is
still enabled.
Meaning: An attempt was made to disable the touch using the
SetTouchMode
command.
Action: Select Debug from the Test Menu and examine the
Trace history to determine more about the condition.
Message: Touch System Initialization Failed
Meaning: CTDIAG cannot successfully complete initialization.
Action: Select Debug from the Test Menu and examine the
Trace history to determine more about the condition.
Message: Touch System Init Failed - Corrupted
Report Received
Meaning: An expected report was corrupted during initialization.
Action: Select Debug from the Test Menu and examine the
Trace history to determine more about the condition.
Message: Touch System Init Failed - Expected
Report Not Received
Meaning: An expected report was not received during
initialization.
Action: Select Debug from the Test Menu and examine the
Trace history to determine more about the condition.
Message: Touch System Init Failed - Unable To
Open Com Port
Meaning: The touch system cannot communicate with the comm
port correctly. This error usually occurs on the first
attempt to initialize the touch system.
Action: Check for the correct comm port and I/O address
specified on the command line.
Table A-1. Error Messages (Continued)