User's Manual

UM600694 Rev B, page 63 of 73
User Manual – Elo I-Series 4.0 Backpack
About Android Debug Bridge (ADB) control
Elo
Elo I-Series 4.0 Backpack supports debugging via Wi-Fi/Ethernet or using the USB Type-c to type-A cable.
Note: For USB debugging, a USB 3.0 Type A to Type A cable must be used.
Set I-Series 4.0 Backpack to (Developer)
• Enter Settings → About Phone → Build Number.
• Tap Build Number 7 times to enter developer mode.
• Go back to the Settings → System → Advanced and you will see “Developer Options”.
• From Developer options on- screen display, enable the option called “USB debugging”.
To connect via Wi-Fi
Ensure that your computer is online and not behind a firewall.
• Find the IP address (by going to Settings → Network & Internet → Wi-Fi →Tap the active connection → Advanced→ IP Address.
• On your host computer, use the command ADB connect <IP address> to be able to perform ADB actions.
To connect via USB, perform the following steps
• Ensure the USB cable is not connected to the I-Series 4.0 Backpack.
• From the settings, enter Developers Options
• Turn on the “Enable USB Debugging” option
• Plug USB cable (type A) side into the computer device and (type A) to host PC.
• In the host PC, input “ADB devices” to check if the Elo I-Series 4.0 Backpack serial number shows
up. If it is there, then you have connected successfully.