User guide

ManualsBrandsElo ManualsOtherWallaby™ POS Stand

1 Add 15X using (4) M4 x 8L screws provided

with stand.

2 Route cables from 15X through cable clips,

add cable ties provided.

For mounting rear-facing display 1002, go to step 4

For adding printer, continue to step 2

QIG, Wallaby POS Stand for X-Series E847771

Summary of content (5 pages)

PAGE 1
QIG, Wallaby POS Stand for X-Series E847771 1 Add 15X using (4) M4 x 8L screws provided with stand. 2 Route cables from 15X through cable clips, add cable ties provided. © Copyright 2018 Elo Touch Solutions, Inc.
PAGE 2
QIG, Wallaby POS Stand for X-Series E847771 2 For Epson TM-T88 series printer, lift up tab on base of stand (to help position printer). For Epson TM-T20 series, keep tab down. 3 Attach cables to printer and place into stand. © Copyright 2018 Elo Touch Solutions, Inc.
PAGE 3
QIG, Wallaby POS Stand for X-Series E847771 4 Remove 3 covers; push off using 5 Add (2) screws to top VESA mount screw driver from behind. holes on back of 1002. Leave gap 6 Route cables through clip. © Copyright 2018 Elo Touch Solutions, Inc.
PAGE 4
QIG, Wallaby POS Stand for X-Series E847771 6 Route 1002 cables through stand bottom hole, add 1002 to stand top holes. Tighten (2) screws. Return to step 1 for mounting 15X and printer. © Copyright 2018 Elo Touch Solutions, Inc.
PAGE 5
QIG, Wallaby POS Stand for X-Series E847771 For more information, go to www.elotouch.com/support, or call the office nearest you. Elo reserves the right to change or update, without notice, any information contained herein; to change, without notice, the design, construction, materials, processing or specifications of any products; and to discontinue or limit production or distribution of any products. Elo, the Elo logo and Wallaby are either trademarks or registered trademarks of Elo Touch Solutions, Inc.