Instruction Manual

Instruction manual I ELOshield
Rev. 20 09.03.2020 Page 25 of 85
6.3 Inputs/outputs
Inputs
 Input 1 – the seat sensor should be connected, or the input should be left unconnected and
deactivated in the configuration software.
 Input 2 –unused in default configuration
Outputs
 NC/NO relay 1 – activated by default, when an object is present in the zone which is closer
 NC/NO relay 2 – activated by default, when an object is present in the zone which is further
 Open collector digital output 1
 Open collector digital output 2
In principle, the relays control the creeping mode or vehicle locking.
6.4 Zones
The shape of the zone is closely dependent on the device configuration and the number of installed
vehicle antenna modules (A):
 1 vehicle antenna modules (A) – circular zone.
 2 vehicle antenna modules (A) – combination of circular zones, symmetric zone.
 3 or 4 vehicle antenna modules (A) – combination of circular zones and custom shaped
zones. Custom shaped zones allow for establishing a precise position of the detected object.
System with 4 vehicle antenna modules (A) is recommended for large vehicles.
6.5 Mechanical installation
CAUTION
Beware of electrical voltage and heat!
Touching live parts can result in injuries. Also, a short circuit can occur which
causes components to be heated. This can lead to injuries.
 The power supply must be disconnected when working on electrical
components.
 Metal objects such as rings or watched must be removed beforehand.
 Connection, testing and measuring work on electrical parts may only be carried
out by a qualified electrician.
 If the electrical parts are faulty or damaged, turn off the electrical power supply
immediately and initiate repair.
 Cabling must be installed according to local laws, electrical standards and the
technical properties of ELOshield and other connected devices.