Instruction Manual

Instruction manual I ELOshield
Rev. 20 09.03.2020 Page 33 of 85
Figure 11. Wiring diagram of system elements
Each vehicle antenna module (A/B) and stationary antenna module (A/B) requires a unique
hardware CAN ID to be set. The procedure is described in the previous chapter.
6.6.1 Assigning connection cables
Assigning the X1, 9 x 0.34 wire
Signal desig-
nation
Wire color Technical data Comments
Power + Red 12 – 48 VDC, filtered
(Tolerance:  10%)
Power supply voltage
Apply voltage from a stabilized
source only
The device is equipped with a
2A fuse
Power - Blue Power supply ground Negative pole of power source
Q
X2 cable, relay outputs,
6 wires
Antenna module
(A or B) # 1
Antenna module
(A/B) # 2
X1 cable, power, outputs, inputs, 9 wires
X3 cable, vehicle module to
antenna module (A/B), 4 wires
X4 cable, antenna
module (A/B) to
antenna module
(A/B), 4 wires
CAN ID
CAN ID