Instruction Manual

Instruction manual I ELOshield
Rev. 20 09.03.2020 Page 37 of 85
7. Use and operation of the stationary module
The stationary module is used for detecting pedestrians and vehicles in circular and symmetric or
custom shaped zones. Depending on its configuration, the device will control output signals or start
an action of the vehicles when detecting an object within the range of the zone. The stationary set
is most often used as a control device for industrial automatic control system.
The stationary set consists of a stationary module and antenna modules (A and/or B) connected to
it. It is possible to integrate the stationary module and one stationary antenna module (A or B) into
a single casing. Such solution decreases the number of devices and cables requiring installation
works. In this variant, the proper positioning of the device is very important.
The stationary module should be installed in a location allowing for access to its terminals located
in the lower part of the device. It is important to maintain visibility of the LEDs located on the front
of the device as they inform about the device condition.
Figure 12. Picture of the stationary set with an optional signal column.
7.1 Warning and informing
Status LED:
 Off – the stationary module is switched off
 Blinking green – the stationary module is active
 Blinking red – the auto-test is active
 Continuous red – failure
 Blinking yellow intermittent – the muting is active