Instruction Manual

Instruction manual I ELOshield
Rev. 20 09.03.2020 Page 56 of 85
o Internal zones – when inner zones
are selected, the panel used for
signaling the breached zones uses its
own configuration for zones i.e. 300
cm and 600 cm, as shown in the
picture above. When inner zones are
off, the panel works based on
information about breached zones
from other devices. For example, if
we want the vehicle to react to the
zones defined on the stationary
panel, inner zones cannot be
selected.
o LED intensity – indicates the light
intensity in percentage as generated
by LEDs on the panel.
o Zone 1 (alarm) sound intensity – indicates the sound signal loudness in percentage
as generated by the panel, when the module is in the alarm zone.
o Zone 2 (warning) sound intensity – indicates the sound signal loudness in
percentage as generated by the panel, when the module is in the warning zone.
o First zone sound pulsation – indicates the single sound duration as generated by the
stationary/vehicle module, when the module is in the alarm zone.
o Second zone sound pulsation – indicates the single sound duration as generated by
the stationary/vehicle module, when the module is in the warning zone.
o First zone blinking frequency – indicates the red LEDs blinking frequency, when the
device is in the alarm zone.
o Second zone blinking frequency – indicates the yellow LEDs blinking frequency,
when the device is in the warning zone.
o First zone stationary/vehicle module sensitivity – indicates device types, which will
interact with the stationary/vehicle module in the alarm zone.
o Second zone stationary/vehicle module sensitivity – indicates device types, which
will interact with the stationary/vehicle module in the warning zone.
 Muting mode – this is a mode, in which the stationary/vehicle module does not interact with
other devices. It is intended for long term muting and therefore it is manually configured.
o Switching on/off the possibility to activate the muting mode
o Muting mode duration – specifies the time during which the stationary/vehicle
module will not interact with other devices.