User's Manual

Infant Protection Bracelet – User Guide _____________________________________________________________________________________________
Preparing the Bracelet for Use
1. Hold the Tag, Front Side Up in one hand and the
disposable kit in the other.
2. Place the Cap on the tag making sure that the
cap’s wide edge matches the wide edge of the
tag.
Attaching the Bracelet
1. Place the Bracelet around the baby’s ankle such
that the cap part of the disposable tamper band is
always on top.
2. Using the grip key, adjust the Band Length as
needed to obtain a snug fit around the baby's
ankle.
3. Then remove the Grip Key by turning it counter-
clockwise
4. Finally position the Bracelet on the baby's ankle as
shown here
Removing the Bracelet
1. Pull gently on the Tag as far as possible from the infant’s ankle. Using baby-safe
scissors cut either side of the Ankle Wire as close to the tag as possible.
NOTE: It is highly recommended to perform a match test between the Mother tag and Infant
Protection Bracelet before removing the bracelet and releasing the mother with the baby
(Refer to the Nurse Station BabyMatch III Users Guide for more information).
Removing the Disposable Tamper Band
2. Push the tag gently through the Extractor Tool
until it clicks into place.
3. Press firmly on the Cap; then release the
Tag from the Disposable Kit with your hand.
4. Then safely discard the Disposable Kit according
to hospital guidelines.
Cleaning and Disinfection Procedures
1. Clean the Rechargeable Tag (with the snap-on cap attached) by using the appropriate
antibacterial solution.
NOTE: Do not remove the used snap-on cap prior to cleaning (this allows the contacts to remain free
of cleaning solutions, shorts, etc).
2. Remove the used Disposable Tamper Band and with a soft cloth or a wipe, clean the top
part of the Rechargeable Tag.