User's Manual

ManualsBrandsElpas Solutions ManualsElectronicsB07

Baby Tag Instruction Manual and Spec-Sheet

FCC Compliance

The FCC Wants You to Know

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

tuning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

a) Reorient or relocate the receiving antenna.

b) Increase the separation between the equipment

and receiver.

c) Connect the equipment to an outlet on a circuit

different from that to which the receiver is

connected.

d) Consult the dealer or an experienced radio/TV

technician.

FCC Warning

Modifications not expressly approved by manufacturer could

void the user authority to operate the equipment under FCC

rules.

IR and RF Baby Tag

P/N: BKB00001 (433.92 MHz)

Baby Tag

Summary of content (4 pages)

PAGE 1
Baby Tag Instruction Manual and Spec-Sheet FCC Compliance The FCC Wants You to Know This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Description A small tag, attachable to a baby’s ankle, capable of transmitting Infra Red signals in addition to RF signals in the frequency of 433.92 MHz. The tag is used for security monitoring (abduction and mismatch prevention) of infants whereabouts in real time, in hospitals’ Maternity Wards. The tag sends a unique message when the ankle band has been tampered with and disconnected. Recommended use is with the ELPAS BabyWatch system.
PAGE 3
Tag’s Disposable components Weight (when assembled) Temperature: Operating Temperature: Storage Water resistance Accessories • Light green snap-on cover • Disposable band • White connector • Assembly set • Insulator • Sticker 20 gram -10 to 70°C -20 to 60°C Waterproof Baby Tag Disposable Kit P/N BKB09001 IR Transmission Peak optical transmitted power Peak transmission wavelength Peak radiant intensity Frequency of transmission Transmission angle 500mW 880nm 120 mW/Sr Carrier at 455 KHz 360° badge plan
PAGE 4
Using the Baby Tag The following is a set of procedures to ensure proper use of the Baby Tag. To use the Baby Tag: 1. Place the Baby Tag band around the baby's ankle. 2. Gently pull at both loose ends of wire until the strap is well wrapped (but not tightened) around the baby’s ankle. 3. Hold the Baby Tag using two fingers of one hand, ensuring that the activating set, comprising of the thumbscrew and hook, is held straight. 4. Close the thumbscrew. 5.