User's Manual

Page 2 315 Wireless HART
FCC Notice:
This device complies with Part 15.247 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This device must be operated as supplied by ELPRO. Any changes or modifications made to the device
without the written consent of ELPRO may void the user’s authority to operate the device.
This device must be installed by professional installers in compliance with 47 CFR Part 15 Subpart C
Section 15.204 and 15.205, who will be responsible for maintaining EIRP no greater than 36 dBm in
accordance with 47 CFR Part 15 Subpart C Section 15.247 (b)(2)(4).
In accordance with 47 CFR Part 15 Subpart C Section 15.204 only the following antenna/coax cable
combinations can be used with each radio.
WIFI Antenna
Manufacturer Model Number Coax Cable Net
ELPRO MD2400-EL Includes 5m Cellfoil 2dBi Gain
ELPRO SG2400-EL CC3-SMA (3m) 2dBi Gain
ELPRO Z2400-EL CC10-SMA (10m) 4dBi Gain
ELPRO Y2400-EL CC20-SMA (20m) 6dBi Gain
WI HART Antenna
Manufacturer Model Number Coax Cable Net
ELPRO Z2400-EL CC3-SMA (3m) 6dBi Gain
ELPRO Y2400-EL CC3-SMA (3m) 14dBi Gain
Please insure correct antennas are connected to the appropriate antenna port
 Part 15 – This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC rules (Code of Federal Regulations 47CFR Part 15).
Operation is subject to the condition that this device does not cause harmful interference.
 Notice – Any changes or modifications not expressly approved by ELPRO could void the user’s
authority to operate this equipment.
To operate this equipment legally the user must obtain a radio operating license from the government
agency. This is done so the government can coordinate radio users in order to minimize interference.
This Device should only be connected to PCs that are covered by either FCC DoC or are FCC certified.
SAFETY Notice:
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard for
human exposure to radio frequency electromagnetic energy emitted by FCC regulated equipment as a
result of its actions in Docket 93-62 and OET Bulletin 65 Edition 97-01.