User manual

905U-G Wireless Gateway User Manual
Page 43 ©September 2004
screen will appear where you may enter the system address.
If you are editing an existing project, the system address will already have been entered. Do
not change the system address
unless you are going to re-
program all of the modules in
the system.
Password. You have the
option of entering a password to
protect the configuration files
against unauthorized changes.
When you open a new project,
you will be asked to enter a
password - if you do not enter
any text - that is, press “ESC”
or “Enter”, then password
protection is disabled. If you do
enter a password, then you will
need to enter this password to
access the project. Without the
password, you are unable access
the project
The password can be between 6
and 256 characters. You can
also change password at any
time by over-typing the
passowrd.
If you are starting a new project, you have the option of “Enabling Security”. This option
enables encryption of
the data sent over the
radio. - please read
Section 4.2.2 and the
associated warnings
before using this
option.
To proceed with the
configuration, double-
click on the project
name on the menu on
the left side of the
screen. “Units” will
appear. You can now
enter the types of units
which will be used in
the system. If you double-click on “Units”or select the “+” sign beside “Units”, then the
modules that have already been created will be displayed.