User's Manual

Page 32 E2 Wireless I/O
Open the side configuration panel and set the #6 Dipswitch to ON Switch to the ON
position. This will always start the E2 with Ethernet IP address 192.168.0.1XX, subnet
mask 255.255.255.0, gateway IP 192.168.0.1 and the radio disabled. Do not forget to
set the switch back to the OFF position and restart the module at the conclusion of
configuration.
Power up the E2 module.
Open “Network Settings” on your PC under Control Panel. The following description is
for Windows XP - earlier Windows operating systems have similar settings.
Open “Properties” of Local Area Connection.
Select Internet Protocol (TCP/IP) and click on Properties.
On the General tab enter IP address 192.168.0.1, Subnet
mask 255.255.255.0 and press “OK”
Open Internet Explorer and ensure that settings will allow
you to connect to the IP address selected. If the PC uses
a proxy server, ensure that Internet Explorer will bypass
the Proxy Server for local addresses.
This option may be modified by opening Tools -> Internet
Options -> Connections Tab -> LAN Settings->Proxy
Server -> bypass proxy for local addresses.
Enter the default IP address for the E2
https://192.168.0.1XX where XX is the last two digits of
the serial number.
Enter the username “user” and default password “user”.