User's Manual

E2 Wireless I/O Page 33
Figure 1 – Welcome Webpage
To resume normal configured operation when Configuration is complete, switch Factory
Default dip-switch on the E2 to RUN and cycle power.
Note: Security Certificates. Configuration of the E2 uses an encrypted link (https). The
security certificate used by the E2 is issued by ELPRO and matches the IP address
192.168.0.100.
When you first connect to the E2, your web browser will issue a warning that ELPRO is
not a trusted authority. Ignore this warning and proceed to the configuration web page.
To avoid seeing this warning in future, you can install the certificate into your browser.
Internet Explorer 7 has an additional address check on security certificates. Unless the
E2 has the address 192.168.0.100, when you first connect to the E2, Internet Explorer
7 will issue a warning about mismatched security certificate address. You can turn off
this behaviour in IE7 by selecting
“Tools > Internet Options > Advanced > Security > Warn about certificate address
mismatch*”