User's Manual

Page 36 E2 Wireless I/O
Radio Settings
Transmit Power
Level
This allows adjustment of the radio power. Do not set the
radio power above the allowed setting for your country You
can reduce the power for short range applications, or to
allow the use of high gain transmitter antennas while still
complying with the emission requirements of your country.
See “Appendix D” for dBm to mW conversion
Transmit Data Rate
• The radio baud rate in Mega (million) bits per second
(Mbps) for point to point radio transmissions. The
default value is Auto. Select a fixed rate to force the
radio to use the selected rate. Select a fallback rate
to allow the radio to select a lower rate if there are
communications problems. Normally an Access point
is configured with either auto or a fallback data rate to
allow clients to connect with different data rates.
Channel
Select available channel, frequency and bandwidth from
drop down list. Australia only has 1 channel available
(Channel 41).
Radio Channels 1 to 11 may be configured at the Access
Point. Default radio channel is set to 3.
Save Changes
Save changes to non-volatile memory. The module will need
to be restarted before the changes take effect.
Save Changes and
Reset.
Save settings to non-volatile memory, and reboot E2. Once
the module has completed the reboot sequence, all
changes are in effect.