User's Manual

Page 38 E2 Wireless I/O
4.5 WIBMesh Mappings
Selecting WIBMesh Mappings from the right hand
side of the main menu will show the I/O
Configuration screen.
This is where you configure Read, Write and
Gather/Scatter mappings as well as any Sensitivity
Blocks.
Write Mappings
Add or delete mapping by using the buttons then select “Save and Activate Changes”.
Block Write Mapping
Destination IP
This is the IP address that you wish to write the I/O to.
Ack
Selecting this box will mean the mapping will be
acknowledged
Invert
This will allow the mapping to be inverted. E.g. if the digital
input is on and inverted then the output will be off and visa
versa. Applies to all the I/O in the mapping and can only be
used with Words and Bits, No Floating Point or Long values
Update Period
This is the period that the mappings are sent as an update or
check signal.
Update Offset
Allows an offset to be configured for each mapping. Used to
stagger the transmissions so on start-up the module does not
try to send all mapping at the same time. Default it will be 0
however the normal would be around 10 minutes
COS Delay
You can enter a delay period such that the message is
delayed from sending for the configured time. Used to hold
off the transmissions to allow more COS (Change of State)
messages to be added to the mapping.