User's Manual

Page 40 E2 Wireless I/O
Update Offset
Allows an offset to configured for each mapping. Used to
stagger the transmissions so on start-up the module does not
try to read all mapping at the same time. Default it will be 0
however the normal would be around 10 minutes
Response Timeout
Time before a response Failure is registered
Force Reg
Register location that when written to will force the Read
Mapping to be sent. E.g. External device can initiate the
transmissions.
Fail Reg
Register location that will indicate a failure to communicate
with the remote Destination Address configured
First Local Reg
Starting Local address that values will be written to.
First Remote Reg
Starting Remote address that the values will read from.
Reg Count
Total number of register values (consecutive)
Save Changes
Save changes to non-volatile memory. The module will need
to be restarted before the changes take effect.
Save Changes and
Reset.
Save settings to non-volatile memory, and reboot E2. Once
the module has completed the reboot sequence, all changes
are in effect.
Gather/Scatter Write Mappings
Gather/Scatter Write Mapping
Destination IP
This is the Module IP address that you wish to read I/O from.
Ack
Selecting this box will mean the mapping will be
acknowledged
Invert
This will allow the mapping to be inverted. E.g. if the digital
input is on and inverted then the output will be off and visa
versa. Applies to all the I/O in the mapping and can only be
used with Words and Bits, No Floating Point or Long values
Update Period
This is the period that the mappings are sent as an update or
check signal.