User's Manual

Radio/Serial Telemetry Module User Manual
Page 32 © March 2000
For -2 and -3 modules, the default configuration is as follows :-
The following table details the default values for User Options :
Option Factory Set Value
Update transmissions Every 10 minutes
Analogue Change-of-state sensitivity 3%
Reset outputs on Comms fail No
Analogue Setpoints (if mapped) Low Set point = 30%
High Set point = 75%
Pulse Output Rate Scaling
(if Pulse Rate is mapped)
100 Hz
Digital Input Debounce Time 0.5 seconds
If any of the above values are not appropriate to your system, Section 4.4 below will detail how to
change one or all of the above variables.