User's Manual

105 Radio/Serial Telemetry Module User Manual
Page 44 © March 2000
105-3 None
Accuracy 10 bit, Digital filter time
constant 1 second (config.)
Analogue Input Setpoints 105-1 AI 1 only
105-2 AI 1-6
Configurable high & low set-points,
allowing set/reset of remote digital
outputs
Analogue Outputs 105-1 Two 4-20mA
105-2 None
105-3 Eight 0-20mA
current sink to common, max loop
voltage 27V,
Resolution 15 bit
Accuracy 10 bit (0.016mA)
System Parameters
Network Configurations Communications via radio or
RS485 or network of both
Up to 95 radio units with up to 32
serial units off each radio unit
Mapping Any input to any output in
system
User Configuration Via on-board DIP switches
or RS232 terminal or laptop
Diagnostics
On board diagnostics Automatic check on start-up
Via RS232 terminal or laptop
Input status
Output test
Incoming radio signal level
Simple radio path testing