User's Manual

Appendix A System Example

man_905_2.1.doc Page 55

Tank Station Configuration

The 105U-2 module has the following configuration :-

Note the following points in the configuration :

• The configuration software used was CFG105-2.EXE as the module is a 105U-2.

• The system address is 10587 (a random selection) and unit address is 2.

• PIN1 (the flow meter) is mapped to Out3 (D/P output 3) at #96 which is the control station -

#1 is a repeater.

• The pulse rate for this PIN (PLSR1) is mapped to Out2 at #97 via #1. This is AO2 of the

105S-3 at the control station. Remember that the 105S-3 has two addresses - the lower

address is used for the digital outputs, and the higher address is used for the analogue outputs.