User's Manual

105 Radio/Serial Telemetry Module User Manual
Page 58 © March 2000
Control Station Configuration
The 105S-3 module has the following configuration :-
Note the following points in the configuration :
• The configuration software used was CFG105-3.EXE as the module is a 105S-3.
• The system address is 10587 (same as before) and unit address is 96. As the module is a 105-3
module, it will automatically assume addresses #96 and #97.
• The only mappings are Start-up polls. Note that there are two separate polls, one for each
remote module.
• D/P Out 3 has been configured as a PO. Its pulse output update time is the same as the PI
update time at the remote module (both have been left at their default value of 1 minute).
• Comms fail reset times have been selected for the analogue outputs (21 minutes) but not the