User's Manual

Elpro Technologies E2-450 Radio Transceiver Module Instruction Manual
2 www.cooperbussmann.com/wirelessresources Rev Version
1.0
ATTENTION!
Incorrect termination of the supply wires may cause internal damage. Before turning the power on double-check ALL
connections by referring to this User Manual.
CAUTION
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device
must be installed to provide a separation distance of at least 90 cm from all persons to satisfy RF exposure
compliance.
DO NOT
Operate the transmitter when anyone is within 90 cm of the antenna. 
Operate the transmitter unless all RF connectors are secure and any open connectors are properly 
terminated.
Operate the equipment near electrical blasting caps or in an explosive atmosphere. 
All equipment must be properly grounded for safe operations. All equipment should be serviced only by a qualified
ELPRO staff only.
FCC Notice:
Part 90 – This device has been type accepted for operation by the FCC in accordance with Part90 of the FCC rules
(47CFR Part 90). See the label on the unit for the specific FCC ID and any other certification designations.
Note: This device should only be connected to Devices that are covered by either a FCC DoC or
are FCC certified.
Antenna Models:
Manufacturer
Model Number
Net
ELPRO
CFD940
2 dBi Gain
ELPRO
SG900EL
5 dBiGain
ELPRO
SG940-6
8 dBi Gain
ELPRO
YU6-940
11 dBi Gain