Measurement Guide

ROD SETS

INSTALLATION INSTRUCTIONS

NOTE: Finial shown is for illustration purposes only.

It may not represent the style of finial purchased.

STEP 1:

If screws are going directly into wood trim or wall studs, drill a 1/8" pilot

hole at pencil marks. If screwing into drywall, follow instructions on

enclosed sheet.

STEP 3:

Assemble rod and slide drapery treatment

onto rod.

Place brackets against wall at desired locations.

Mark screw holes with pencil. Be sure marks are

level across opening.

STEP 4:

Screw finials onto rod. Rotate finial on rod for proper

alignment if required.

STEP 5:

Extend rod to desired width. Lift rod with drapery

and drop into brackets. Adjust draperies to

desired position.

STEP 6:

Lock rods into position by tightening leveling

screw by hand until finger tight. This will prevent

the rod from moving.

Drapery

STEP 2:

PAGE 1
ROD SETS INSTALLATION INSTRUCTIONS NOTE: Finial shown is for illustration purposes only. It may not represent the style of finial purchased. STEP 1: Place brackets against wall at desired locations. Mark screw holes with pencil. Be sure marks are level across opening. STEP 2: If screws are going directly into wood trim or wall studs, drill a 1/8" pilot hole at pencil marks. If screwing into drywall, follow instructions on enclosed sheet. STEP 3: Assemble rod and slide drapery treatment onto rod.