User guide

37
No image
Make sure the camera is power on.
Make sure the monitor has enough charge
/ connect it to AC/DC adaptor.
Move the camera closer to the monitor; it
might be out of range or flip the antenna of
the receiver to obtain best possible
reception.
Make sure the camera is paired to the
correct channel.
Re-“pair” the camera and receiver
Flip the antenna of the receiver to obtain
best possible reception.
Clean the camera lens using lens cleaning
cloth.
The motion sensor not
working
Increase or decrease the sensitivity of the
motion sensor (see page 21).
Check the settings on the RECORD
screen (see page 24).
No recording happens
although it has the
schedule set.
Ensure correct DATE AND TIME has been
set and the Record Schedule setup
correctly.
Ensure the memory card is inserted into
DVR and formatted.
There might be no movement detected,
i.e.: no moving object to trigger the motion
sensor.
Unable to pair the camera
to the receiver
Make sure the camera is power on.
Press and release the pairing button
quickly. Do not press and hold.
Power off the receiver and restart. If power
button does not respond, use a pin to
press the reset button.
A white image
appears at night
The camera's infra-red LEDs shine
invisible light that reflects of surfaces such
as glass will cause white light. Place the
camera on the other side of windows to
TROUBLE SHOOTING
TROUBLE SOLUTIONS
Screen lock may be on. Tap the Power
button to unlock the screen.
The receiver and
cameras are on but there
is no image on the screen
Poor picture quality