QUICK GUIDE User Manual

HA68 QUICK GUIDE
Connect adaptor and insert batteries at control panel (9/10)
Insert batteries
Remote control 7
PIR motion detector 13
Magnetic contact 17
Registration of remote control (27)
Press on control panel (24)
- KEY - PIN CODE (default code= 1234)
- ENTER = Display shows 1 user setup
- ENTER = 1-1 admin setup
- ENTER = Password
Navigate with arrow keys to 6 remote (19)
- ENTER = 6-1 learning ID
- ENTER = wait for learning
Now press OFF button on remote control
Display = learning ok = ok
= time out = pressed too late
= ID duplicate= remote control is already registered
Press and hold ESCAPE button to leave programming mode.
Remote control is now available.
Registration of detectors (36)
Press on control panel
- KEY - PINCODE (default code=1234)-ENTER
Display shows 1 user setup
Navigate with arrow keys to 3 zone setup
- ENTER = input 3-1 ser (01-36) zone selection with number keys starting
with 01
- ENTER = wait for learning
Now press sabotage switch on detector to be registered
Display = learning ok = ok
= time out = pressed too late
= ID duplicate= remote control is already registered
Repeat this procedure with all detectors to be registered; Combination of zones
is freely selected. Press and hold ESC button to leave programming mode.
You will find complete instructions in the manual.