User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 56 6. Using the VersaProbe
3. You are ready to read meters using the VersaProbe (see “Reading a meter” on page
56).
Reading a meter
When the VersaProbe is ready for the reads (see “Establishing the VersaProbe connection”
on page 55):
1. Hold the VersaProbe up to the meter.
2. Press the trigger button and then release it within less than four seconds.
If Enable sound option is enabled, a success or fail sound will alert you with the
result of reading.
Note: If
Auto Display
is checked the handheld will automatically display the VersaProbe
Connection screen to read the meter. If it is not checked, press <V> at the main
menu screen or Meter Readings screen to show the VersaProbe Connection
screen.