User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 57 6. Using the VersaProbe
3. Click OK to return to the Meter Readings screen.
You will be returned to the last Account screen you were on, not to the account that
was just updated. However, the read will be updated in the account as shown
below.
• Elster PI software will match the VersaProbe read to the correct account using the
probe encoder number, no matter what route the account is found in.
• If the encoder number is not found in any route, then a mismatch error will be
displayed.
• If the VersaProbe is used in the disconnected mode, then the handheld device will
take each stored reading from the VersaProbe and match it to the correct account
after the VersaProbe is reconnected to the handheld device.