User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 58 6. Using the VersaProbe
Note: If you return to the Account screen for the encoder you just read and the read value
is -2, press <Enter> to refresh the screen. The read value is replaced by a positive
number indicating the reading.
Note: If AutoMove is on, press <Enter> again to advance to the next Account screen.
4. When ready to unload the stored reads, connect the VersaProbe to the handheld
device and press the VersaProbe’s trigger to start the unload process.