User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 62 7. Installing RTMs
Installing an RTM
The RTM installation screen and process will vary slightly depending on whether the meter
is a gas or water meter, and the generation of the RTM. The table below details the
specifics of each RTM generation.
The screens for Gen 5 gas and water installation are shown below.
RTM
Generation
Meter Type RTM Serial Number FCC ID Programming Notes
2.0 Water, Gas < 2500000 G8J3GNAMR8 Programming Stick
2.5 Water (pit)
≥ 2500000 ≤ 6500000
G8JPIT25 magnet
2.5 Water (remote)
≥ 2500000 ≤ 6500000
G8JGEN25 Programming Stick
3.x Water (remote)
≥ 2500000 ≤ 6500000
G8JGEN03 magnet
Gas (remote)
≥ 2500000 ≤ 6500000
G8JGEN03 jumper
5.0 Gas (direct) > 6500000 G8JVRT01
Water (remote, integral) > 6500000 G8JVRT02
Water (pit) > 6500000 G8JVRT03
Gas (standalone) > 6500000 G8JVRT04