User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 73 7. Installing RTMs
2. Select the appropriate Installation Definition Code from the list.
Note: Code 99 is reserved for upgrading the module firmware using a file obtained from
Elster Customer Support. Use this code only if directed to by Elster.
Note: Refer to the
Route Manager User Guide
for details on configuring Installation
Definition Codes.
3. Enter the visual read index value in the Mt Rd.
— Or —
If you wish to use the default values, select the Installation Definition Code = 0.
a. Enter the PreD value.
b. Enter the PCF value.