User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 About handheld devices
- 3 Handheld operation
- 4 About Interrogator software
- 5 Reading accounts
- 6 Using the VersaProbe
- 7 Installing RTMs
- 8 RTM Verification
- 9 Communicating with Route Manager
- 10 Setting up devices in Route Manager
- A Accelerator keys for meter reading
- B Accelerator keys for installing RTMs
- C Troubleshooting
- D Programming Pre Gen 5 RTMs
- Index
Elster Handhelds
User Guide 87 10. Setting up devices in Route Manager
Make sure the following values are added correctly.
Scanner and GPS properties
Property Value
Probe Baud Rate: 9600
Probe ComPort: Select the appropriate ComPort:
• Com8 for Bluetooth Communication
• Com1 for Serial Communication
Probe Bluetooth ID: Select appropriate Bluetooth ID of the device
Note: You will find this ID in the VersaProbe
communication mode and It is created in Route
Manager under
Configuration > Misc Codes >
VersaProbe Bluetooth ID > Create.