Instruction manual

14
AUDIO SETUP (5.1Ch model)
There are eight available settings:
AUDIO OUT
You can choose to send the player’s audio signals to
an external receiver using the following outputs:
 ANALOG:
Audio signals are sent using stereo (L/R) audio
terminals. Selecting this choice will disable the
digital audio outputs.
 SPDIF/RAW:
Set to this selection will output the raw bit stream
signal of Dolby
®
Digital or DTS from the coaxial jack.
In order to enjoy Dolby
®
Digital DTS discs, this unit’s
digital output jack must be connected to the
digital-input jack of a Dolby
®
Digital or DTS
compatible receiver or processor.
 SPDIF/PCM:
PCM stands for Pulse Code Modulation and is digital
audio. Connecting this unit to an amplifier with a
built-in D/A converter can play the same digital audio
format as on CDs. Additionally, 2-channel analogue
audio will output from the audio output jacks of
amplifier.
NOTES:
 Analogue and digital audio signals cannot output simultaneously.
 This player has a conversion function for converting Dolby
®
Digital and MPEG audio into the LPCM format. This allows
playback of CDs with the regular playback system without the
need for a special converter.
DOWN MIX
 LT/RT
Please connect to a built-in Dolby Pro Logic receiver
or amplifier to enjoy the Dolby Pro-Logic surround
sound.
 STEREO
Down mixed Stereo L/R audio output.
 VSS
Virtual Surround Sound audio output.
 OFF
Turn off the DOWN MIX function to enable the 5.1ch
setting items.
- - AUDIO SETUP PAGE - -
AUDIO OUT
DOWN MIX LT/RT
CENTER STEREO
REAR VSS
SUBWOOFER OFF
CNTR DELAY
REAR DELAY
TEST TONE
SET DOWNMIX MODE


- - AUDIO SETUP PAGE - -
AUDIO OUT ANALOG
DOWN MIX SPDIF/RAW
CENTER SPDIF/PCM
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SELECT AUDIO OUTPUT

