User's Manual Part 1

1.5 PACKAGING CONSIDERATIONS
The factory cartons include a printer placed inside a protective ESD (Electrostatic Discharge)
bag and suitable form-fitting foam cushions. Testing of this packaging has confirmed its ability to
withstand the forces required by equipment transporters. If any other shipping materials are
used, related shipping damage may not be covered by the warranty. If necessary, order
replacement factory-approved shipping materials from a 3M MAXSecure distributor.
1.6 PREPARING A STATIC-SAFE WORK AREA
To avoid component damage while performing troubleshooting and repair procedures, service
personnel should prepare a static-safe working area. This area should include a properly
grounded, conductive, cushioned mat to rest the Printer Module on and a conductive wrist strap
to ground the servicing technician. (Most electronic supply stores carry ESD protective devices.
For a local supplier, contact 3M Corporation at 1-800-328-1368 or 512-984-1800).
1.7 ENVIRONMENTAL AND SHOCK PROTECTION
Avoid extremes of temperature and humidity or mishandling. These conditions can damage
most electronic equipment.
When moving the printer from a cool, dry location to a warmer, more humid location, allow the
printer to temperature stabilize for at least 30 minutes before opening the protective ESD bag.
Otherwise, moisture can condense on the surface of many components. Moisture can degrade
performance or even damage some components.
Avoid rough handling. Careful handling can avoid possible mechanical damage that might
otherwise result from dropping or impacting the printer on a hard surface.
980286-001 Rev. A 1-9
CHAPTER 1
GENERAL DESCRIPTION