User's Manual Part 1
Table Of Contents
- TABLE OF CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 INSTALLATION AND OPERATION
- 2.1 INSTALLATION 2-2
- 2.2 OPERATION 2-6
- 2.2.1 Controls and Indicators 2-6
- 2.2.2 LCD Messages Related to Printer Module 2-7
- 2.2.3 LCD Messages Related to Laminator Module 2-7
- 2.2.4 LCD Messages Related to Encoder Module 2-8
- 2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads 2-8
- 2.2.6 LCD Messages Related to Cleaning 2-8
- 2.2.7 Print Head Latch and Release Levers 2-9
- 2.2.8 Ribbon Installation 2-10
- 2.2.9 Card Media 2-11
- 2.2.10 Clear Card Material Loads 2-11
- 2.2.11 White Card Feeder Loading 2-12
- 2.2.12 Two- verses Three-Layer Selection 2-13
- CHAPTER 3 THEORY OF OPERATION
- CHAPTER 4 TROUBLESHOOTING
- CHAPTER 5 REPLACEMENT PROCEDURES
- TABLE OF FIGURES
- Figure 2-8. Clear Card Material Loads. 2-11
- Figure 2-9. White Card Hopper Loading. 2-12
- Figure 2-10. Card Layer Selection Lever. 2-13
- Figure 3-1. 3M MAXSecure Card Path. 3-7
- Figure 3-2. Block Diagram. 3-9
- Figure 4-1. Problems Duplicated by a Test Print. 4-2
- Figure 4-2. Interface Diagnostic Flow. 4-5
2.1.2 Location Concerns
Users should avoid locations with heavy concentrations of airborne contaminates. Until ready to
use, keep Clear Card material and White Cards in their cartons. Such care also applies to
Cleaning Roller Sheaths. Handle all ribbon and card media in a way that avoids contamination.
Fingerprints and other such contaminants can lower image quality. Select a location that offers
easy access to all sides and unrestricted air flow for ventilation. Avoid locations that experience
extremes in temperature and/or humidity.
2.1.3 Adding the Laminator and Die Cutter
Figure 2-2 shows how the Printer Module and Laminator and Die Cutter fasten together.
CAUTION: To avoid damage, separate the Modules prior to any move to a new location.
Step 1. As shown, align the left side of the Printer Module with he right side of the
Laminator and Die Cutter Module.
Step 2. Lift the Laminator and Die Cutter Module to engage the hooks with the Printer
Module slots. Make sure that the pin on the Laminator Module aligns with the slot
in the Printer Module.
980286-001 Rev. A 2-3
CHAPTER 2
INSTALLATION AND OPERATION
Figure 2-2. Laminator Installation.