User's Manual Part 1
Table Of Contents
- TABLE OF CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 INSTALLATION AND OPERATION
- 2.1 INSTALLATION 2-2
- 2.2 OPERATION 2-6
- 2.2.1 Controls and Indicators 2-6
- 2.2.2 LCD Messages Related to Printer Module 2-7
- 2.2.3 LCD Messages Related to Laminator Module 2-7
- 2.2.4 LCD Messages Related to Encoder Module 2-8
- 2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads 2-8
- 2.2.6 LCD Messages Related to Cleaning 2-8
- 2.2.7 Print Head Latch and Release Levers 2-9
- 2.2.8 Ribbon Installation 2-10
- 2.2.9 Card Media 2-11
- 2.2.10 Clear Card Material Loads 2-11
- 2.2.11 White Card Feeder Loading 2-12
- 2.2.12 Two- verses Three-Layer Selection 2-13
- CHAPTER 3 THEORY OF OPERATION
- CHAPTER 4 TROUBLESHOOTING
- CHAPTER 5 REPLACEMENT PROCEDURES
- TABLE OF FIGURES
- Figure 2-8. Clear Card Material Loads. 2-11
- Figure 2-9. White Card Hopper Loading. 2-12
- Figure 2-10. Card Layer Selection Lever. 2-13
- Figure 3-1. 3M MAXSecure Card Path. 3-7
- Figure 3-2. Block Diagram. 3-9
- Figure 4-1. Problems Duplicated by a Test Print. 4-2
- Figure 4-2. Interface Diagnostic Flow. 4-5
2.2.4 LCD Messages Related to Encoder Module
LCD Message Description
ENCODER BUSY Encoder is Busy; Printer Waiting to Send Card
ENCODING ERR Error During Encoding
WAIT ENCODER Error Reprint Wait–Encoder Finishing
CARD ENCODER A Card is in the Encoder
NO CARD ENCODER No Cards in Encoder
MAGNETIC ERROR Communications Error Between Printer and Encoder
CLEAN MAG HEAD Clean Magnetic Encoder
2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads
LCD Message Description
COMMAND ERROR Command Not Recognized by Printer
PARAMETERS ERROR Command Received has Imporper Parameters
REMOVE CLEAR Can appear During Improper Sensor Adjustment
ERR NO SPLICE Cannot Detect Splices due to Sensor Adjustment
NO ACCESS Printer Password Required for Command Sent
FLASH ERROR Error Detected During Firmware Download
KEY TO EXIT Offers Exit Opportunity During Testing—Press Button
2.2.6 LCD Messages Related to Cleaning
LCD Message Description
CLEANING PRINTER Time to Clean Printer—Press Panel Button when Ready to Begin
REMOVE RIBBON Remove the Ribbon Before Continuing
REMOVE CARD Cleaning Card at Exit Requires Removal
NO CLEANING CARD Place New Cleaning Card at Clear Material Load Point
REMOVE CLEAR Remove Cleaning Card
CLEANING CUTTER
A Clear Card Shear Cleaning/Sharpening Sequence is Running (Follows Splice
Removal After OUT OF CLEAR Message)
2-8 980286-001 Rev. A
CHAPTER 2
INSTALLATION AND OPERATION