User's Manual Part 1
Table Of Contents
- TABLE OF CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 INSTALLATION AND OPERATION
- 2.1 INSTALLATION 2-2
- 2.2 OPERATION 2-6
- 2.2.1 Controls and Indicators 2-6
- 2.2.2 LCD Messages Related to Printer Module 2-7
- 2.2.3 LCD Messages Related to Laminator Module 2-7
- 2.2.4 LCD Messages Related to Encoder Module 2-8
- 2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads 2-8
- 2.2.6 LCD Messages Related to Cleaning 2-8
- 2.2.7 Print Head Latch and Release Levers 2-9
- 2.2.8 Ribbon Installation 2-10
- 2.2.9 Card Media 2-11
- 2.2.10 Clear Card Material Loads 2-11
- 2.2.11 White Card Feeder Loading 2-12
- 2.2.12 Two- verses Three-Layer Selection 2-13
- CHAPTER 3 THEORY OF OPERATION
- CHAPTER 4 TROUBLESHOOTING
- CHAPTER 5 REPLACEMENT PROCEDURES
- TABLE OF FIGURES
- Figure 2-8. Clear Card Material Loads. 2-11
- Figure 2-9. White Card Hopper Loading. 2-12
- Figure 2-10. Card Layer Selection Lever. 2-13
- Figure 3-1. 3M MAXSecure Card Path. 3-7
- Figure 3-2. Block Diagram. 3-9
- Figure 4-1. Problems Duplicated by a Test Print. 4-2
- Figure 4-2. Interface Diagnostic Flow. 4-5
2.2.9 Card Media
3M Products offers the following Card media:
Description Part Number
Kit containing Clear Card roll and White Cards for 2-Layers
104523-055
Kit containing Clear Card roll and White Cards for 3-Layers
104523-060
2.2.10 Clear Card Material Loads
Refer to Figure 2-8, and proceed as follows:
Step 1. Place a roll of Clear Card Material onto the holder such that the loose end
feeds from the bottom of the roll.
Step 2. With power on, feed the loose end through the two sets of guide rollers and
then into the top of the Clear Card Feed Station. When sensed, the Printer Module
automatically advances the material to a point below the Shear.
980286-001 Rev. A 2-11
CHAPTER 2
INSTALLATION AND OPERATION
Figure 2-8. Clear Card Material Loads.