User's Manual Part 1
Table Of Contents
- TABLE OF CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 INSTALLATION AND OPERATION
- 2.1 INSTALLATION 2-2
- 2.2 OPERATION 2-6
- 2.2.1 Controls and Indicators 2-6
- 2.2.2 LCD Messages Related to Printer Module 2-7
- 2.2.3 LCD Messages Related to Laminator Module 2-7
- 2.2.4 LCD Messages Related to Encoder Module 2-8
- 2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads 2-8
- 2.2.6 LCD Messages Related to Cleaning 2-8
- 2.2.7 Print Head Latch and Release Levers 2-9
- 2.2.8 Ribbon Installation 2-10
- 2.2.9 Card Media 2-11
- 2.2.10 Clear Card Material Loads 2-11
- 2.2.11 White Card Feeder Loading 2-12
- 2.2.12 Two- verses Three-Layer Selection 2-13
- CHAPTER 3 THEORY OF OPERATION
- CHAPTER 4 TROUBLESHOOTING
- CHAPTER 5 REPLACEMENT PROCEDURES
- TABLE OF FIGURES
- Figure 2-8. Clear Card Material Loads. 2-11
- Figure 2-9. White Card Hopper Loading. 2-12
- Figure 2-10. Card Layer Selection Lever. 2-13
- Figure 3-1. 3M MAXSecure Card Path. 3-7
- Figure 3-2. Block Diagram. 3-9
- Figure 4-1. Problems Duplicated by a Test Print. 4-2
- Figure 4-2. Interface Diagnostic Flow. 4-5
Problems Associated with Print Anomalies
Symptom Possible Causes
References
Adjustment
or Cleaning
Replace-
ment
No Image
CPU Board
Head Up/Dn Motor
Switch Sensors
5.2.20
5.2.16
5.2.16
Faint Image
Low Print Head Voltage
Dirty Print Head
6.2.1
5.2.23
Artifacts Particles on Feed or Transport Rollers
6.2.3
Horizontal Lines Dirty or Damaged Print Head Element
6.2.1 5.2.10
Multiple
Evenly-Spaced
Horizontal Lines
CPU Board Print Head Registers
5.2.20
Vertical Lines Stepper Transport Belts Too Tight
6.3.5
Sticking Ribbon Peel Bar Adjustment
6.3.2
Washout Peel Bar Adjustment
6.3.2
Sheared Ribbon Image Not Centered
6.3.3
Image Off Center X- and Y-Offset Values
6.3.3
CMYK Not
Aligned
Erratic Card Feed due to Belt Tension
or dirty rollers
6.3.5, 6.3.6
6.2.3
Abrupt Color
Change
Initialization
Flag Sensor
Clutch Pads
Ribbon Take-Up Motor/O-Ring
2.2.1
5.2.16
5.2.17
5.2.16
980286-001 Rev. A 4-3
CHAPTER 4
TROUBLESHOOTING