User's Manual Part 1
Table Of Contents
- TABLE OF CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 INSTALLATION AND OPERATION
- 2.1 INSTALLATION 2-2
- 2.2 OPERATION 2-6
- 2.2.1 Controls and Indicators 2-6
- 2.2.2 LCD Messages Related to Printer Module 2-7
- 2.2.3 LCD Messages Related to Laminator Module 2-7
- 2.2.4 LCD Messages Related to Encoder Module 2-8
- 2.2.5 LCD Messages Related to Adjustments, Testing, and Microcode Downloads 2-8
- 2.2.6 LCD Messages Related to Cleaning 2-8
- 2.2.7 Print Head Latch and Release Levers 2-9
- 2.2.8 Ribbon Installation 2-10
- 2.2.9 Card Media 2-11
- 2.2.10 Clear Card Material Loads 2-11
- 2.2.11 White Card Feeder Loading 2-12
- 2.2.12 Two- verses Three-Layer Selection 2-13
- CHAPTER 3 THEORY OF OPERATION
- CHAPTER 4 TROUBLESHOOTING
- CHAPTER 5 REPLACEMENT PROCEDURES
- TABLE OF FIGURES
- Figure 2-8. Clear Card Material Loads. 2-11
- Figure 2-9. White Card Hopper Loading. 2-12
- Figure 2-10. Card Layer Selection Lever. 2-13
- Figure 3-1. 3M MAXSecure Card Path. 3-7
- Figure 3-2. Block Diagram. 3-9
- Figure 4-1. Problems Duplicated by a Test Print. 4-2
- Figure 4-2. Interface Diagnostic Flow. 4-5
Problems Associated with Card Transport Failures
Symptom Possible Causes
References
Adjustment
or Cleaning
Replacement
No Clear Card
Feed
Clear Card Material Not Below Shear
LED Indicates SPLICE
Clear Card Feed Station Rollers Dirty
Clear Card Feed Motor, Belt, or pulleys
Clear Station PCBA or IC
2.2.10
2.2.2
6.2.3
5.2.6, 5.2.7
5.2.22
No Cut and Clear
Card Material
Feeds Past Cut
Point
Lower Clear Card Feed Station Sensor
5.2.7
No White Card
Feed
Card Weight Not on Card Stack
Warped White Card
Dirty Card Feed Roller
Card-Feed Motor
Card-Feed Belt
Layer Lever Set for 3-Layers
2.2.11
6.2.3
2.2.12
5.2.3
5.2.3
Multiple Card Jam
Card Sensor
Card Sensor Adjustment
Layer Lever Set for 2-Layers
Card Weight Not in Place
Appendix A
2.2.12
2.2.11
Partial Card Feed
Rear Stepper Motor or a Transport Belt
Card Sensor
Broken Belt or Slipping Pulley
6.3.5
6.3.5, 6.3.6
5.2.16
5.2.19
5.2.14, 5.2.16
Stall at Cleaning
Roller
Card Sensor
Cleaning Roller not or improperly Installed
6.2.2
5.2.19
5.2.13
Stall in Printer
Station
Card Transport Belt
5.2.14, 5.2.16
4-4 980286-001 Rev. A
CHAPTER 4
TROUBLESHOOTING