User's Manual Part 2

5.2.13 Cleaning Roller Spring Clip Replacement
Figure 5-17 shows the spring clip that holds the Cleaning Roller in place above the first feed roller
of the Printer Station. Proceed as follows:
Step 1. Swing down the Front Panel (see Section 3.2.1).
Step 2. Remove the Cleaning Roller, and unhook the spring that applies a downward
force on the combined clip and Cleaning Roller.
Step 3. Remove the two screws that hold the clip. Note that both screws have
shoulders that tighten against the chassis while giving the clip a degree of free
vertical movement. Servicing personnel must not use any other screw type as a
fastener for this clip.
980286-001 Rev. A 5-19
CHAPTER 5
REPLACEMENT PROCEDURES
Figure 5-17. Cleaning Roller Spring Clip.