User's Manual Part 2

6.3.4 Pressure Roller Position
Card jams in the lower part of the Clear Card Feeder can result from a pressure roller not
positioned parallel to the associated drive roller. To adjust this roller, refer to Figure 6-6, and
proceed as follows:
Step 1. Remove the rear and right case members (see Section 5.2.1).
Step 2. Without unplugging its connectors, remove the White Card Feeder fasteners,
and move the unit enough to access the Clear Card Feeder (see Section 5.2.2).
Step 3. Loosen the two screws holding the Pressure Roller bracket.
Step 4. Position the upper edge of the bracket parallel to the upper edge of the
underlying Card Guide with each side spaced equally.
Step 5. Install the White Card Feeder and Case members.
6-10
980286-001 Rev. A
CHAPTER 6
MAINTENANCE AND ADJUSTMENTS
Figure 6-6. Lower Clear Card Feeder Pressure Roller Adjustment.