User's Manual Part 2

5.2.6 Lower Clear Card Station Removal
Refer to Figure 5-6, and proceed as follows:
Step 1. Remove the Upper Clear Card Station (see Section 5.2.4).
Step 2. Remove White Card Feeder Station sufficiently to gain clearance from the
Lower Clear Card Station (see Section 5.2.2).
Step 3. Remove connectors on the Clear Card Controller board that connect to the
Lower Clear Card Station and J17 on the CPU Extension board (see Figure 5-26).
Step 4. Remove the fasteners holding the Clear Card Controller board, and swing the
board away from the underlying Lower Clear Card Station fasteners.
Step 5. Remove the fasteners holding the Lower Clear Card Station, both front and
back. Then, while feeding the cables through the cutouts in the Rear Plate, lift the
unit away from the Printer module.
5-8
980286-001 Rev. A
CHAPTER 5
REPLACEMENT PROCEDURES
Figure 5-6. Lower Clear Card Station.