Product specifications

OmniFocus 200 Series Installation and Operation Guide
4. The graphics card of your computer should detect the projector. Adjust desktop settings
to enable the second monitor (extended displays mode). Default resolution is 1920 x 1200.
It may be helpful to use either the truncated or fulldome Elumenati alignment image as your
desktop background. Again use desktop settings to change your background making certain
that the image is displayed 1:1 and not stretched or tiled.
5. Once you have a proper signal from the projector, you are ready to proceed to lens in-
stallation. You may turn off the projector at this point if you wish, though it is not neces-
sary.
Lens Installation
1. If you have purchased a 200 Series stand, please assemble it according to the directions
located at the end of this manual. If you are not using the stand, place the projector on a
flat, sturdy surface to allow mounting of the lens.
2. The lens is secured using a magnetic bayonet mount.
● Remove the small lens cap on the projector side of the lens.
● Insert the lens into the mount and rotate until the magnets engage (Fig. 4).
● If using the folded lens (30210) ensure that the pins on the lens align with the grooves
in the mount (Fig. 5).
3. You are now ready for first light.
Immersive Projection Design - www.elumenati.com
Elumenati, GeoDome OmniFocus and OmniMap are all trademarks of The Elumenati LLC.
(Fig. 4) Magnetic mount
(Fig. 5) Note groove for folded lense at top of
mount