Owner manual

8
Connectors
Please pay attention to operate the museq with the correct voltage setting for your country and
the proper pin assignments on the XLR connectors.
Mains module
This module combines the line cord connector, the on/o switch, the fuse holder with in-
tegrated 230/115 VAC voltage selector and a line lter for providing the transformer with
clean current.
WARNING: High voltage
Make sure to disconnect the line cord before replacing eventually blown fuses or changing
the operating voltage of the unit! In order to change the operating voltage, the fuse holder
has to be taken out and re-inserted so that the desired voltage can be read correctly (and is
not standing upside down). Note: Some export versions have a xed voltage of e.g. 100 or
115 VAC and cannot operate at 230 VAC.
WARNING: Fuses
Always make sure to use the correct fuses for the chosen voltage: 230 VAC 0.8 A Slo-Blo or
115 VAC 1.6 A Slo-Blo. Incorrect or missing fuses are dangerous safety hazards for both the
unit and yourself!
Brightness trimmer
You can use a small screwdriver to adjust the light intensity of the front panel logo disc.
Audio outputs (+4 dBu)
Pin assignment balanced: 1 ground 2 hot (+) 3 ground
Pin assignment unbalanced: 1 ground 2 hot (+) 3 idle
Audio inputs (+4 dBu)
Pin assignment balanced: 1 ground 2 hot (+) 3 cold (-)
Pin assignment unbalanced: 1 ground 2 hot (+) 3 ground
Note: If a device that is placed in the signal chain before the museq has an unbalanced
output stage, a complete mute can eventually occur when the equalizer is activated. If this
happens, please follow the advice on the next page.
BASICS – Connectors
Left Output
2 Hot Gnd 1
Gnd
3
2 Hot Gnd 1
(Idle)
3
- Balanced -
- Unbalanced -
Left Input
1 Gnd Hot 2
Cold
3
1 Gnd Hot 2
Gnd
3
- Balanced -
Right Output
2 Hot Gnd 1
Gnd
3
2 Hot Gnd 1
(Idle)
3
- Unbalanced -
Right Input
1 Gnd Hot 2
Cold
3
1 Gnd Hot 2
Gnd
3
Made in Germany
elysia GmbH • D-41334 Nettetal • Germany
WARNING!
DO NOT OPEN - RISK OF ELECTRIC SHOCK!
Voltage
220 - 240 VAC
~ 50 Hz
110 - 120 VAC
~ 60 Hz
Fuse Type
0.8 A Slo-Blo
@ 220 - 240 VAC
1.5 A Slo-Blo
@ 110 - 120 VAC
Power Consumption 60 W
BASICS