Installation Guide

TECHNICAL FILE
R03.001_29/12/2010
Technical Information
You can nd out more information about the technical features of Emac®’s products by downloading
their Technical File from www.emac.es
If you have any query, please contact our Technical Department in [e-mail]
The data provided are only for information and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail]// Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
Novolistel® XS
Indoors Wall tiling Flooring Recyclable
Page 3 de 3
1 2 3 4 5
As a ooring separator
1. Spread a big amount of thin-set mortar on the surface to be tiled.
2. Then, place the prole and press it so the thin-set mortar passes through the holes of the anchoring
wing.
3. Place a tile on the anchoring wing and press it to get an optimal contact with the thin-set mortar.
4. Repeat the the previous step by placing tiles both sides the prole until the installation is complete.
5. Finally, clean the leftover material, remove the protective lm if necessary and let dry.
* If you are planning on polishing the oor, install the prole slightly below the tile.
To see the video, capture this
image with your mobile phone
(QR code reader software is ne-
cessary) or click on it.
Cleaning and maintenance
The proles should be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry to remove excess moisture.
You can clean the anodized nishes, if dirtiness persists, with a suitable slightly abrasive cleaning pro-
ducts or with specic metal cleaners. The lacquered nishes are more delicate and must be cleaned
with neutral detergents using soft cloths with no abrasive particles that could damage the surface
treatment. You can obtain a polished nish in natural nishes by using specic metal cleaners such as
magic cotton or generic polishers.
In all cases the steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric
and perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommen-
ded. Citric acid is not recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).