Installation Guide

TECHNICAL DATA SHEET
R03.002_03/03/2022
You can nd out more information about the technical features of EMAC®’s products by downloading
its Technical File in www.emac.es.
If you have any query, please contact our Technical Department in [e-mail].
Technical information
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail] // Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Novopeldaño ASTRA® Nori
Installation
ASTRA® is resistant to most of the common cleaners, although is recommended cleaning it preferably
with neutral cleaners and water. The correct use of bleach does not affect it and it is resistant to the
most common acids. If you need to clean the striated surface deeply, you can use a brush to clean.
It is not recommended using organic solvents suc as ethyl acetate, acetone or tolueno, so they could
damage the surface appearance.
Cleaning and maintenance
Materials
The Emac®’s ASTRA® material is an extra resistant polymer specially developed to obtain the best
benets in all kind of environments. Not only indoors but also in submerged or humid environments
or outdoors. Thanks to the addition of biocides, which prevent from mold growing, it stands stable in
humid and submerged environments. This material has a great impact resistance, improved in the
formulation with several additives and a perfect balance of mineral reinforcer, which allows its use in
oorings with guarantees.
The colors available are stable and durable, thanks to the studied dosage of maximum solidity dyes,
preserving its appearance along the time. ASTRA® is the result of the constant innovation in Emac®,
always working to offer highly functional and decorative products.
Novopeldaño ASTRA® Nori is to be installed easily on nished oorings:
1. Clean the surfaces to join to guarantee a perfect adhesion
2. Spread a big amount of adhesive on the rear side of Novopeldaño ASTRA® as well on the support,
so the whole surface is covered with adhesive. Follow the instructions of the adhesive manufacturer.
3. Place the prole on the desired location, align it to the vertex of the support and press rmly to join
both surface.
In installations with butt joint or connections it is recommendable to keep a small separation by way
of expansion joint which should be greater the longer the proles to join are. Approximately 2 mm/m.
This joint can be sealed with elastic lling suitable for outdoors.
4. Let dry the adhesive and remove the leftover. Respect the drying time established by the adhesive
manufacturer before transit over the prole.
* Emac® recommends using a white two-component epoxy polyurethane reactive adhesive type
Pegoland® Elastic from Grupopuma or similar. The adhesive life is about one hour.
Novopeldaño ASTRA® Nori can be bent by applying heat in both directions, however limited in the
exterior bend. For more information, see the Novopeldaño ASTRA® Videocool.
3/3
INDOOR
INTÉRIEUR
INTERNI
RECICLABLE
RECYCLABLE
RECYCLABLE
RICICLABILE
OUTDOOR
EXTÉRIEUR
ESTERNO
FLOORING
PAVEMENTS
PAVIMENTI
PAVIMENTOS
SUBMERGED
IMMERGÉ
SOMMERSO
SUMERGIDO
BENDABLE
COURBABLE
CURVABILE
CURVABLE