Use and Care Manual

TECHNICAL FILE
R03.001_16/01/2012
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail] // Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
You can nd out more information about the technical features of Emac®’s products by downloading
its Technical File in www.emac.es.
If you have any query, please contact our Technical Department in [e-mail].
Technical information
If you want to install Novoperi as a nishing and you don’t want to tile the front part of the installation,
just follow the instructions detailed above and obviate the two rst steps.
Installation
Cleaning and maintenance
Indoors Wall tiling Recyclable
Page 2 of 2
Novoperi
Stair nosing
As a nish (countertops, windowsills...)
1. Spread a big amount of thin-set mortar on the surface of the riser.
2. Place tiles on the riser and press them to get an optimal adherence.
3. Then, spread a big amount of thin-set mortar on the tread and align the prole to its vertex so it
rests on the riser (Do not let overhang, the leverage may remove the step and the tiles). Then press
it to let the thin-set mortar pass through the holes of the anchoring wing.
4. Place a tile on the tread, align it to the prole and press them to get a perfect adhesion. You can
tap it softly with a rubber hammer.
5. Clean the possible leftover material and let dry.
The cleaning must be done periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry to remove excess moisture. If dirtiness persists, clean the
prole with a solution with clean water and detergent or neutral soap 5%, brushing with a cloth that
has no particles that could scracht the nish. Ensure the lacquered surface is totally cold (maximum
20ºC) before the cleaning.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).
The Earthen oxide, Oxidized gray, Misty white and Quarz sand nishes have been lacquered, obtaining
so a high quality and homogeneus surface. The lacquering has the quality seal Qualicoat, which gua-
rantees the quality of the process and the nal products.
Aluminum has excellent chemical, physical and mechanical properties. It is lightweight, tough, ductile,
malleable and highly durable.
Outdoors