Installation Guide

TECHNICAL FILE
R03.001_04/05/2015
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail] // Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
You can nd out more information about the technical features of Emac®’s products by downloading
their Technical File from www.emac.es.
If you have any query please contact our Technical Department in [e-mail]
Technical Information
Novopletina Aluminum
Cleaning and maintenance
Installation
Page 2 de 2
Indoors Pavements
Novopletina Aluminum can be installed in any type of nished oorings. It is delivered with counter-
sunk holes to be xed with screws. Each 2,5 m prole has 13 countersunk holes. The rst is located at
50 mm from the end of the prole, while the rest are at 200 mm between centers. It is recommended
a countersunk screw 3,5 x 30 mm.
Please, clean the surfaces to install to guarantee a perfect adhesion. After that, place the prole, mark
the holes, drill and x using the appropriate screws.
Outdoors
The product must be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry it to remove the humidity excess. The persistent dirtiness can
be removed by using cleaning approved agents lightly abrasive or a grid covered with polished powder
neutral. If a preserving agent is applied, as well as keep a very thin layer of water repellent, note that it
can’t be yellow,attract dust or dirt or have iridescent effects.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).